Center Drive – High efficiency gear motor delivers exceptional torque to propel your system over the roughest terrain and through difficult soil conditions.
3 Output RPMs
- Low 60:1 ratio or 29 RPM
- Standard 40:1 ratio or 43 RPM
- High 25:1 ratio or 70 RPM
Helical Gear Design – 95% efficiency
● All aluminum gear case and motor housing assures cooler running, longer life and increased corrosion resistance
● Multi-bolt mounting pattern fits most brands
● High-strength steel shafting provides long life and dependability
● Thermally protected with automatic reset located in easily accessible junction box
● Heat-treated gears
● Specially designed input and output seals
● Top fill plug positioned to set correct oil level
● All critical electrical connections are encapsulated to resist moisture penetration
● Use of smaller generators and smaller incoming wire sizes is possible
● C.S.A. approved
● Stainless junction box cover
● Dual shaft seals
● New high capacity outer motor bearing
Heavy-Duty Wheel Gearbox Redefines Durability
Backed by the industry’s best warranty, covering the cost for both the gearbox and labor, Reinke gearboxes are built to provide years of dependable service.
- Input shaft cover snaps on to either end to guard against seal and shaft damage
- Unique rolling diaphragm design minimizes positive and negative pressure build-up during operation – relieving negative pressure prevents water and contaminants from being drawn into the gear case
- Stainless steel diaphragm cover provides years of corrosion-free life
- Larger input bearings (largest in the industry) provide 55% greater load capacity for today’s larger tires and faster rotation times
- Non-seizing drain and fill plug for easy maintenance
- Cartridge style input and output seals utilize a multi-lip design and a precision ground, polished sealing surface to all but eliminate oil leaks
- End cap is machined from cast steel to handle the higher loads created with today’s larger tires
- Seal protector blocks out contaminants and extends seal life
- New Bull Gear, designed for greater tooth contact, results in higher load capacity and longer life
- Large 2 1/4″ diameter output shaft and flange are made of high-strength steel to carry tower loads
- Centering ring doubles as a load-bearing surface, relieving stress on the lug bolts and lessening potential wheel damage
- Reinforced housing provides more material in high stress areas, increasing overall gearbox strength
- Dual input shaft provides universal mounting
- Output seal features two double-lipped seals with grease-filled gap for extended life
Replacing the standard gear oil with Sprinkler Lube 1200™ after the first season will provide exceptional lubrication with minimal maintenance while extending the life of the wheel gears.
